Sony R-DG1200 - Manual (Page 120)

120 US
D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\100REM.fm masterpage: Left
STR-DG1200
3-289-135-11(1)
3
Press the button for the
operation you want to perform
to learn the function as follows.
The input button selected in step 2 flashes
twice, then lights up again.
4
Repeat steps 2 and 3. When you
want to assign another
command for the same
component, repeat step 3.
5
Press RM SET UP to finish the
programming process.
Tip
If the RM SET UP button flashes five times in
step 1, and the macro programming process
does not start, replace the batteries with new
ones.
To cancel programming
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
The previous command remains valid.
Starting macro play
1 Press AMP.
The AMP button lights up, and then turns
off.
2 Press MACRO 1 or MACRO 2 to start
the macro.
The macro starts and execute the
commands in the order you assigned them.
While the commands are being sent, the
AMP button flashes and the RM SET UP
button lights up. When the commands have
been sent, the AMP and RM SET UP
buttons light off.
To erase a programmed macro
1 While holding down RM SET UP, press
MACRO 1 or MACRO 2 for more than 1
second to clear the stored macro.
The RM SET UP button flashes.
2 Press RM SET UP.
Settings stored as macro are cleared.
Press Operations to be
programmed
N, x, X,
M, m,
., > Performs the operation
of the button.
The input
button for more
than 1 second Switches inputs.
MACRO 1 or
MACRO 2 Make a one second
interval. When you want
to make a longer
interval, press MACRO
1 or MACRO 2
repeatedly.