Sony R-DG1200 - Manual (Page 44)

44 US
D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\030CON.fm masterpage: Left
STR-DG1200
3-289-135-11(1)
9
Measurement starts.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• When connecting special speakers, such as dipole
speakers, the measurements may not be performed
correctly or Auto Calibration cannot be performed.
To cancel the measurement
The measurement is cancelled when you
change the volume, activate the muting
function, switch functions, change the setting
of SPEAKERS (OFF/A/B/A+B), press GUI
MODE, or connect headphones.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
Note
When the speaker(s) is (are) out of the phase,
“Out Phase” is displayed on the TV screen.
The “+” and “–” terminals of the speaker may
be connected the other way around. However,
depending on the speakers, “Out Phase”
appears on the TV screen even though the
speakers are connected properly. This is
because of the speakers’ specifications. In this
case, you can continue to use the receiver.
Tip
The displayed unit of distance is feet. You can
change the unit of distance to meters in
“Distance Unit” in the Speaker settings menu.
Confirming/saving the
measurement results