Sony R-DG1200 - Manual (Page 46)

46 US
D:\NORMAN_PC\JOBS\SONY HA\STR-DG1200\U\3289135111\01US-
STRDG1200CEL\030CON.fm masterpage: Left
STR-DG1200
3-289-135-11(1)
* xxx represents a speaker channel.
F Front
FL Front Left
FR Front Right
CNT Center
SL Surround Left
SR Surround Right
SB Surround Back
SBL Surround Back Left
SBR Surround Back Right
SW Subwoofer
•Error Code: 31, 32, 33
1 Press B/b to select “Retry”, then press .
2 Press to select “Start”.
3 Follow the instructions from step 7 of
“Performing Auto Calibration”.
When a warning code appears
If a warning on the measurement result is
present, detailed information is displayed.
Press to return to step 1 of
“Confirming/saving the measurement
results” (page 44).
Tip
Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
Message list after Auto Calibration measurement
Message
appears in GUI
menu [Display
window] Explanation
Error Code: 31
[E-xxx: 31]* SPEAKERS (OFF/A/B/A+B) is set to off. Set it to others and perform the measurement
again.
Error Code: 32
[E-xxx: 32]* None of the speakers were detected. Make sure that the optimizer microphone is connected
properly and perform the measurement again.
If the optimizer microphone is connected properly but the error code appears, the optimizer
microphone cable may be damaged or improperly connected.
Error Code: 33
[E-xxx: 33]* • None of the front speakers are connected or only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speakers is not connected.
• Surround back speakers are connected even though surround speakers are not connected.
Connect the surround speaker(s) to the SURROUND terminals.
• The surround back speaker is connected only to the SURROUND BACK SPEAKERS R
terminals. When you connect only one surround back speaker, connect it to the
SURROUND BACK SPEAKERS L terminals.
Warning Code: 40
[W-xxx: 40]* The measurement has completed. However, the noise level is high. You may be able to
perform the measurement properly if you try it again, even though the measurement cannot
be performed in all environments. Try to perform the measurement in a quiet environment.
Warning Code: 41
[W-xxx: 41]* The input from the microphone is too loud. The distance between the speaker and the
microphone may be too close with each other. Retry the measurement after setting them
further apart from each other.
Warning Code: 42
[W-xxx: 42]* The input from the microphone is too loud. The distance between the speaker and the
microphone may be too close with each other. Retry the measurement after setting them
further apart from each other.
Warning Code: 43
[W-xxx: 43]* The distance and position of a subwoofer cannot be detected. This may be caused by noise.
Try to perform the measurement in a quiet environment.
NO WARNING There is no warning information.