Sony HDW-1800 - Manual (Page 95)

95
9-4 Items in the Extended Setup Menu
Chapt
er 9 Set
u
p
Men
u
s
743 P R LEVEL (HD) Adjust the P
R
level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0.0% (0H) to 100% (800H) to 141.3% (B4EH)
745 SETUP LEVEL (HD) Adjust the setup level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0 to 110H to 220H
746 SYNC PHASE (HD) Control the H sync phase of the high-definition video signal output from the HDSDI
OUTPUT connector according to the menu.
0 to 80H to FFH
747 SYNC PHASE FINE (HD) Fine control the H sync phase of the high-definition video signal output from the
HDSDI OUTPUT connector according to the menu.
0 to 3FFH
Menu items in the range 800 to 899, relating to audio control
Item number Item name Settings
801 DIGITAL JOG SOUND Turns the digital jog sound on and off.
OFF: Digital jog sound is turned off.
Audio of digital channels not subjected to speed correction is output. When the
tape stops, after one second the audio is muted.
ON: Digital jog sound is turned on.
When the tape speed is in the range x–1 to x+1, speed correction is carried out,
and the same jog sound as a conventional analog VTR is output.
802 DIGITAL AUD MUTING IN
SHUTTLE MODE Set the digital audio muting conditions during shuttle playback.
OFF: Not muted.
CUEUP: Muted during cueup or preroll operations.
FULL: Muted in shuttle mode.
803 DIGITAL AUDIO FADE
TIME Specify the time for cross-fade or fade in/out editing of digital audio signals.
5ms, 10ms, 15ms, 20ms, 25ms a) , 50ms b) , 85ms, 115ms c)
Note
The cross-fade or fade in/out operation means that the recording is rewritten from
the OUT point for the length specified by this setting. Even at the minimum 5ms
setting, a length of recording corresponding to a field is rewritten.
To avoid rewriting, set menu item 317 “AUDIO EDIT MODE” to “CUT”. In this case
there is an audio discontinuity at the edit point. There is no effect on the recorded
video signal.
805 AUDIO MONITOR
OUTPUT MIXING Select the audio mixing method used for digital audio signals supplied to the
MONITOR OUTPUT connector.
ADD: Simple addition
RMS: Root-mean-square
AVE: Simple average
806 LEVEL METER SCALE Select the digital audio level display mode.
PEAK0: Display the audio level as negative values with the maximum level set to
“0 dB”.
REF.0: Display the audio level as positive and negative values with the reference
level set to “0 dB”.
807 AUDIO OUTPUT PHASE Select the output timing of digital audio playback signals (HDSDI, SDI and AES/
EBU only). The reference position is 80H; when the setting is less than 80H, the
output timing is advanced, and when it is higher than 80H, the output timing is
delayed. (at 80H, 128 samples = approx. 2.7 ms, and 1 sample = approx. 20 µs)
0 to 80 to FF: Set in this range.
Menu items in the range 700 to 799, relating to video control (continued)
Item number Item name Settings