Samsung digimax U-CA 501 - Manual (Page 39)

39
Metering
If you cannot obtain suitable exposure conditions, you can change the metering method to
take brighter pictures.
MULTI( ) : Exposure will be calculated based on
an average of the available light in the
image area. However, the calculation
will be biased towards the centre of the
image area. This is suitable for general
use.
SPOT( ) : Only the rectangular area in the centre
of the LCD monitor will be metered for
light. This is suitable when the subject in the center is exposed correctly,
regardless of the back lighting.
The default metering mode is Multi pattern metering.
If the subject is not the centre of the focus area, do not use the spot metering as this may
result in an exposure error. In this circumstance, It is better to use exposure
compensation.
INFORMATION
Continuous shot
Select the number of pictures in continuous shooting.
- [SINGLE] : Take one picture only
- [2, 4, 8 SHOTS] : Take the set number of pictures with one
push of the shutter. Continuous shooting
mode is cleared after one shooting.
2048
SHOOTING
SINGLE
2 SHOTS
4 SHOTS
8 SHOTS
NOR
[ PROGRAM mode ]
2048
METERING
MULTI
SPOT
2560 NOR 1
1