Star Trac FITNESSTM S-UB UPRIGHT BIKE - Manual (Page 12)

12 STAR TRAC S SERIES BIKES O WNER ’ S M ANUAL
A
SSEMBLY AND
S
ETUP
S SERIES UPRIGHT BIKE
ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC
S-UB / S-UBx UPRIGHT BIKE.
U
NPACKING
Open the shipping carton, remove all parts from the carton and foam
inserts, and verify that the following parts are included in your shipment:
Description
Qty
Bike Frame 1
Display Console Assembly 1
Seat Post Assembly 1
Front Foot 1
Rear Foot 1
Pedals (set of two) 1
Screw, Button Head, M10 X 30 8
Screw, Flat Head, M6 X 16 4
Screw, Socket Head, M6 X 10 1
T
OOLS
R
EQUIRED
Most STAR TRAC bikes can be assembled using the following tools:
n
Metric Hex Key Wrenches
n
Metric Open-End Wrenches
n
Metric Ratchet Socket Wrench Set
n
Torque Wrench
n
Channel Lock Pliers
n
Vice Grip Pliers
n
Rubber Mallet
n
Phillips Head Screwdriver
Your STAR TRAC S-UB / S-UBx UPRIGHT BIKE includes a hex key set and combination open-end wrench.
A
SSEMBLY
1. Install the Front Foot
NOTE:
The front foot assembly has wheels attached to the front
edge. Be sure the wheels face forward when installing the front foot
assembly.
Stand the bike frame upright and place the front foot assembly
under the frame, aligning the holes in the foot with the holes in
the frame.
NOTE: It may be necessary to raise the frame slightly to align the
holes in the frame with the mating holes in the front foot.
Using four M10 X 30 button head screws, secure the front foot
assembly to the frame. Tighten all four screws securely.
Step 1