Star Trac FITNESSTM S-UB UPRIGHT BIKE - Manual (Page 15)

STAR TRAC S SERIES BIKES O WNER ’ S M ANUAL 15
S SERIES RECUMBENT BIKE
ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC S-
RB / S-RBx RECUMBENT BIKE.
U
NPACKING
NOTE:
Complete unpacking instructions are printed on the side of
the shipping carton.
Turn the shipping carton upside-down, and fully open all four
flaps on the bottom of the carton.
Turn the shipping carton right-side up, then lift the carton off of
the foam inserts. Remove all parts and foam inserts, and verify that the following parts are included in your shipment:
Description
Qty
Bike Frame 1
Display Console Assembly 1
Seat Frame Assembly 1
Front Foot 1
Rear Foot 1
Pedals (set of two) 1
Screw, Button Head, M10 X 30 8
Screw, Flat Head, M6 X 16 4
Screw, Socket Head, M6 X 20 4
T
OOLS
R
EQUIRED
Most STAR TRAC bikes can be assembled using the following tools:
n
Metric Hex Key Wrenches
n
Metric Open-End Wrenches
n
Metric Ratchet Socket Wrench Set
n
Torque Wrench
n
Channel Lock Pliers
n
Vice Grip Pliers
n
Rubber Mallet
n
Phillips Head Screwdriver
Your STAR TRAC S-RB / S-RBx RECUMBENT BIKE includes a hex key set and combination open-end wrench.
A
SSEMBLY
1. Install the Front Foot
NOTE: The front foot assembly has wheels attached to the front
edge. Be sure the wheels face forward when installing the front foot
assembly.