Star Trac FITNESSTM S-UB UPRIGHT BIKE - Manual (Page 17)

STAR TRAC S SERIES BIKES O WNER ’ S M ANUAL 17
While holding the power cable connectors together, make a small
“bundle” of the cable, and wrap with electrical tape to prevent the
connectors from separating.
CAUTION: Be careful not to pinch your fingers between the console neck and the bike frame when sliding the console into place.
CAUTION: Be sure not to pinch the display cables between the console neck and the bike frame.
While gently pushing the display cables up into the display console neck, carefully slide the console neck onto the neck brackets
until it is fully seated. Secure the display console to the bike frame with four M6 X 16 button head screws (two screws in front side
and two screws in back side). Tighten all four screws securely.
4. Install the Seat Frame
Carefully position the seat frame over the seat carriage on the bike
frame, aligning the attachment holes in the sides of the seat frame with
the holes in the seat carriage.
Using four M6 X 10 socket head screws, secure the seat frame to the
seat carriage. Tighten all four screws securely.
5. Install the Pedals
NOTE: Turn the left pedal spindle counterclockwise when
threading into the crank arm; turn the right pedal spindle
clockwise when threading into the crank arm.
Install the pedals on the pedal cranks using a 5/8-inch open-end
wrench. Tighten the pedals securely.
6. Leveling the Bike
Place the bike on the floor in the position in which it will be used. Use the leveling adjusters (located on the underside of
the front and rear feet) to compensate for uneven floor surfaces and to eliminate wobbling.
You have now completed assembly of your STAR TRAC S-RB / S-RBx RECUMBENT BIKE.
Step 3c
Step 4
Step 1