Sony DAR-RH7000 - Manual (Page 12)

12
Hookups and Settings
Overview
Complete the following steps to start using this
DVD recorder home theatre system.
Steps 1 to 4 are for the speaker system; steps 5 and
6 for the recorder. After finishing all of the
hookups, connect the mains leads in step 7, and
start setting up the system in “Step 8: Easy Setup.”
Notes
• Plug cords securely to prevent unwanted noise.
• See the instructions supplied with the components to be
connected.
• You cannot connect this recorder to a TV that does not
have a SCART or video input jack.
• Be sure to disconnect the mains lead of each
component before connecting.
Step 1: Unpacking
Check that you have the following items.
• DVD recorder (1)
• Mains lead (1)
• TV aerial cable (1)
• Active subwoofer (1)
• Speakers (5)
• AM loop aerial (1)
• FM wire aerial (1)
• Speaker cords (short) (3)
• Speaker cords (long) (2)
• System cord (1)
• Food pads for the active subwoofer*
1
(4)
• Remote commander (remote) (1)
• R6 (size AA) batteries (2)
• Operating Instructions (1)
• Hookup Guide (card) (1)
The following is also included for speaker
installation.
For DAR-RH7000:
• Speaker stands (2)
• Covers of speaker stands (2)
• Screws (4)
• Foot pads*
2
(20)
For DAR-RH1000:
• Wall-mount pads (8)
*1
Attach to the bottom of the subwoofer.
*2
Attach to the bottom or rear of the speakers.
m
Step 1: Unpacking (page 12)
m
Step 2: Connecting the Speaker System (page 14)
m
Step 3: Connecting the FM/AM Aerials (page 21)
m
Step 4: Connecting the Subwoofer and Recorder
(page 22)
m
Step 6: Connecting the TV and Recorder (page 24)
m
Step 7: Connecting the Mains Leads (page 28)
Step 8: Easy Setup (page 34)
Step 5: Connecting the TV Aerial (page 23)
m