Sharp Aquos LC 32G4U - Manual (Page 55)

55
Using memory card
Recording a motion picture
Record with the settings made in “Rec. Mode” and
“Pre Record”.
Format
4
Press c/d to select “Yes”, and then press
ENTER.
Press MENU and the MENU screen displays.
1
2
Press c/d to select “Card Setup”.
3
Press a/b to select “Format” and then
press ENTER.
No Yes
Press REC to start recording.
• CARD indicator lights up red.
• Recording information displays in the lower
right corner of the screen.
1
2
Press
H to stop recording.
To display the remaining record time.
Press DISPLAY while not recording.
• Remaining record time displays in the lower right corner
of the screen.
NOTE
• Do not press MAIN POWER on the display while
recording. Recording cannot finish properly and may
damage the file.
• Recording stops if you press POWER on the remote
control while recording.
• When card has no capacity for recording, “Card is full”
displays and stops recording.
• You cannot change the channel or switch the input source
while recording.
Displaying a motion picture
Press CARD and the card mode screen
displays.
1
2
Press c/d to select “Video”, and then press
ENTER.
3
Press a/b/c/d to select the file you want
to play, and then press ENTER.
• Video playback starts.
4
Press CARD again to display the operation
panel.
• See XX for the operation panel information.
NOTE
• Formatting a card deletes all files including the ones which
set to protect.
NOTE
The list of broadcasting type or input signal not available
for recording:
1 DTV broadcasting
2 COMPONENT input
3 RGB input
4 Copyguarded signal
5 DVI-I input