Schneider Electric SMART-UPS 750VA User Manual
Operation manual, Smart-ups, X-series ups
Advertising
Table of contents
Document Outline
- About the UPS
- Safety
- Product Overview
- Specifications
- Installation
- Connect Equipment to the UPS
- 1 . Connect equipment to the outlets on the rear panel of the UPS. Do not use extension cords, pl...
- 2 . Connect the UPS to the building utility power. Connect the UPS to a two-pole, three-wire, gro...
- 3 . Press the On/Off button on the front panel of the UPS to apply power to the unit and all conn...
- 4 . To use the UPS as a master on/off switch, turn on all the equipment that is connected to the ...
- Basic Connections
- Display Interface
- Overview
- Using the display interface
- Standard Menus
- • Operating mode
- • Controllable Outlet state, On or Off
- • Efficiency of the UPS
- • Information about the load
- • Battery capacity
- • Estimated runtime
- • Input and output voltage and frequency
- • Information about the last transfer to battery power
- • Self-test results
- • Language
- • Local power quality: Good, Fair, Poor
- • Choose Standard or Advanced menus
- • LCD Display mode, Always On or Power-Saving
- • Audible alarms
- • Reset to Factory Defaults
- • Unit model number
- • Serial number
- • Battery installation date
- • Suggested battery replacement date
- • Replacement Battery Cartridge model number
- • UPS firmware version
- Advanced Menus
- • Energy meter
- • Number of external battery packs connected to the UPS
- • Load current
- • Status of the Controllable Outlet Groups
- • Battery voltage
- • UPS and Controllable Outlet group delays and settings
- • High and lower transfer points
- • Sensitivity settings
- • Date of last battery replacement
- • Hardware version
- • Software version
- • NMC information (if applicable)
- UPS Settings
- Controllable Outlet Groups
- Emergency Power Off
- EPO Overview
- Normally open contacts
- Normally closed contacts
- Service
- 1 . Review the problems discussed in Troubleshooting in this manual to eliminate common problems.
- 2 . If the problem persists, contact APC Customer Support through the APC Web site, www.apc.com.
- a. Note the model number of the UPS, the serial number located on the rear side of the unit, and ...
- b. Call APC Customer Support and a technician will attempt to solve the problem over the phone. I...
- c. If the UPS is under warranty, repairs are free.
- d. Procedures for servicing or returning products may vary internationally. Refer to the APC Web ...
- 3 . Pack the UPS in its original packaging. If this is not available, refer to www.apc.com for in...
- a. Pack the UPS properly to avoid damage in transit. Never use foam beads for packaging. Damage s...
- b. Always DISCONNECT THE BATTERY before shipping in compliance with U.S. Department of Transporta...
- 4 . Write the RMA# provided by Customer Support on the outside of the package.
- 5 . Return the unit by insured, pre-paid carrier to the address given to you by Customer Support.
- Transport the UPS
- APC Worldwide Customer Support
- LIMITED WARRANTY
- © 2009 APC by Schneider Electric. APC, the APC logo are owned by Schneider Electric Industries S....