Star Micronics IFBD-HW03/04 - Manual (Page 31)

IFBD-HW03/04 Product Specifications Rev. 0.00
3.4.2. SNMP Specification
The SNMP of this product has an SNMP engine that operates with UDP/IP. It is possible to control
the product and printer information using the SNMP manager.
• Supports SNMPv1, and MIB-II (RFC1213), Printer-MIB (RFC1759), HostResource-MIB
(RFC1514), and Star’s PrivateMIB.
• “public” has reading permission for the community name, and the character string
registered in the “Authentic Community” for the product setting information has writing
permission. However, if there is no character string set for the “Authentic Community,”
the community name “public” has writing permission.
• Restrictions:
sysContact, sysName, sysLocation are restricted to a maximum of 78 characters (in
single byte characters).
1 is always returned for reading values when ifAdminStatus and ifOperStatus are
read-only.
3.4.2.1. Support MIB
The following describes the MIB that is supported by this product.
Name Explanation
sysDescr ASCII character string of device name; version number
sysObjectID Object ID representing product identification number
sysUpTime Amount of time system is running from startup (in units of 10msec)
sysContact ASCII character string of controller name, and contact information
sysName ASCII character string of domain name for device control
sysLocation ASCII character string representing physical location of device
sysServices Value of service of device protocol hierarchy
ifNumber Number of device network interfaces
ifIndex Interface identification number
ifDescr ASCII character string representing information relating to interface
ifType Physical/link protocol interface type
ifMtu Maximum possible sending/receiving data gram size
ifSpeed Interface transmission speed [bit/sec]
ifPhysAddress Interface physical address
ifAdminStatus Interface control status
ifOperStatus Interface operating status
ifLastChange sysUpTime value when interface operating status changed the last time
ifInOctets Number of bytes received by interface
ifInUcastPkts Number of subnetwork unicast packets received and sent by the upper level
ifInNUcastPkts Number of broadcast and multi-cast packets received and sent by the upper level
ifInDiscards Number of reception packets discarded regardless of being normal packets
because the buffer is full
ifInErrors Number of reception error packets
ifInUnknownProtos Illegal protocols or number of reception packets discarded because it is an
unsupported protocol
ifOutOctets Total number of bytes sent
ifOutUcastPkts Number of send request packets with the unicast from the upper protocol
3-24