Star Micronics IFBD-HW03/04 - Manual (Page 41)

IFBD-HW03/04 Product Specifications Rev. 0.00
:DISABLE
<< Configure SNMP >>
[Authentic Community]
:"******"
[Trap Community]
:"public"
[Trap Address(IP)]
:0.0.0.0
[SysContact]
:""
[SysName]
:""
[SysLocation]
:""
[EnableAuthenTrap]
:2
<< Configure Secure Print >>
[Secure Print]
:ENABLE
[SSL Mode]
:ALL
“*** Diagnostic report ***”
The following shows the self-diagnosis print.
When an error is detected at startup, ”*** Hardware problem report ***” is printed.
<ROM check: Explanation of results of ROM check sum inspection>
First Digit Second Digit Third Digit Fourth Digit
Sum value described in
ROM Sum value actually calculated Always 0 Always 0
NIC check: Shows the results of an NIC packet transmission test. Also, prints the
MAC address.
<EEPROM check: Results of EEPROM check sum inspection>
First Digit Second Digit Third Digit Fourth Digit
Sum value described in
EEPROM Sum value actually calculated Always 0 Always 0
*** Configuration report ***
The following information indicates the environment setting information stored in the
product.
In environment setting printing, when the protocol stack is disabled, information relating
to the disabled protocol is not output.
(The printing example above is the output result using default settings.)
3-34