Sealife DC 600 - Manual (Page 94)

Digital Camera >>
92
7. Do not allow any water droplets to get inside housing. This may
cause the inside of the housing to fog.
8. Close housing lid tightly. Make sure there are no obstructions that
prevent the housing from closing. Make sure lid is tightly pressed
into housing.
9. Close housing latch. Make sure the lid is pressed evenly against the
housing body look for obvious gaps which indicates something is
trapped. The housing may leak if the lid is not evenly against the
housing when closed. It is normal to see a small even gap between the
housing lid and body.
10. Avoid exposing housing to direct sunlight for prolonged periods of
time. This may promote internal fogging.
Test camera and housing
1. Press the small power button on the top of the housing to turn
camera power on.
2. Press the large shutter button on the outside of the housing to take
a test picture.
3. The power or shutter button should have a smooth action and return
to its original resting position after pressing. It is normal to feel
some resistance when pressing the power and shutter button.
4. Press the power button to turn camera power off. It is
recommended to leave camera power off until you’re ready to use
camera to preserve battery power.
5. After 1 minute the camera power will shut down. To operate the
camera, push the POWER BUTTON to turn on the camera.