Shenzhen High Power Tech H7920 - Manual (Page 16)

Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration
M80-792001-01 21
Console Mode
The Galaxy router RS-232 interface can configured for a data communication
port or a Console port. The Console port is only used for factory testing and
trouble shooting.
3.2.1 Router Status
Click "Start"->"Router Status" menu, you will find Galaxy router operation main
information including settings and inbound/outbound data traffic.
This page will display the information:
Mobile Network IP: It is an IP address assigned automatically by
GPRS/EDGE or CDMA 1x network. Normally, it is a dynamic IP
address unless it is bound with the SIM or UIM card.
Mobile Network IP: It is an IP address assigned automatically by
GPRS/EDGE or CDMA 1x network. Normally, it is a dynamic IP
address unless it is bound with the SIM or UIM card.
Mobile Network Subnet: It is a subnet assigned by GPRS/EDGE or
CDMA 1x network.
Peer to Peer IP: It is GPRS/EDGE or CDMA 1x network peer IP
address.
DNS: It is setting parameters at the page DHCP Configuration. Access
it by clicking "Start">"Network Setting">"DHCP Configuration".
Access Point Name: It is APN parameters set at the page of Network
Setting. Access it by clicking "Start">"Network Setting">"Network
Setting".
PPP Status: It displays GPRS/EDGE or CDMA 1x connection online or
offline status and displays online period if the router is connecting
with network. For GPRS/EDGE version, since the clock is
synchronized to an Internet clock sources after connected to
GPRS/EDGE network. Therefore, the online period displayed on this
page may be not correct at the first dial-up.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration
M80-792001-01 22
RF Signal: It displays Galaxy router received GPRS/EDGE or CDMA RF
signal strength in dBm unit. If the received RF signal is lower than
-80dBm, it displays the RF strength with "BAD" word.
Router ID: It is the router's unique identity name for industries and
utilities application. Click "Start">"Special Setting">"DTU Setting" to
modify it.
"Data Traffic" displays Galaxy router inbound/outbound data packets and also
displays packets type and errors.
Packets = Broadcasting Packets + Non-Broadcasting Packets + Loss + Error
Dial Info
Click this button to open detail dial info page:
Start module check.
Module checks OK.
Card ready.
CSQ: 026, 0.
Start dialing
Serial connection established.
Using channel 1
Using interface ppp0
Connect: ppp0 <--> /dev/ttyS1
Remote message:
Local IP address 10.103.32.97 (Note: assigned by mobile operator)
Remote IP address 192.168.100.101 (Note: it is the mobile network server
Thu Jan 18 00:00:30 2005 peer address)
It is a useful tool to check detail dial-up information. Select this option if the
router is unable to dial network, and send the dial-up information to Hongdian
for trouble shooting.
To have more dial-up information, tick the "Dialup Debug Info." at the page of
"PPP Advanced Setting".
(Access it by clicking "Start">"Network Setting">"Network Basic Setting", and
then click the “PPP Advanced Setting”)
3.2.2 Online Help
Click “Start”->"Online Help", a new windows will be opened, and the below
webpage picture appears.