Shenzhen High Power Tech H7920 - Manual (Page 20)

Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration
M80-792001-01 29
Press "Save" button to store the modification.
Reconnecting the host (or PC) after its IP address has been modified
successfully.
Mobile Network Configuration
Those parameters should be configured in accordance with the information
provide by the local service provider.
Service Code
Configure it with a correct service code provided by the service provider, the
default setting:
GPRS/EDGE: *99***1# (for China Mobile)
CDMA 1x: #777 (for China Unicom)
User Name and Password
Input a correct user name and password provides by local mobile service
provider; it will be required for dialing authentication:
For China Mobile's GPRS CMNET user, no user name and password
required. APN user should input correct information provide by
service provider.
For China Unicom's CDMA 1x user, user name is "card", password is
"card".
APN
APN is the abbreviation of access point name; user should apply for it from the
service provider and then have it setup. For example, you can either input
“CMNET"/"CMWAP" for China Mobile or keep it in null. For other service
operators, please consult the local service provider.
Dial
It controls the RF module dialup mode; the default setting is "Auto".
When it is set to "Auto" mode, Galaxy router will automatically dial mobile
network and will re-dial if the mobile link fails. After 3 failed dialing, Galaxy router
will automatically restart RF module. When it is set to "Manual" mode, the timing
work mode for special setting may not be active.
PPP Detecting
It can be enabled or disabled. Also the detecting interval (second) and retries can
be specified accordingly.
The default setting is "Enable", "12" Second interval and "5" tries. With this
setting, the router will detect the PPP link status at 12 Seconds interval for 5
tries. If it is failed continually, the router will re-dial the radio link automatically.
When it fails redialing continually within 3 minutes, the router will be restarted.
Galaxy H7920 Mobile Router User Manual Chapter 3: Router Configuration
M80-792001-01 30
W-ICMP Detecting
The WAN side IP link status detecting can be enabled or disabled. Also the
detecting interval (second), retries and destination (host) can be specified.
The default setting is “disable” since this detecting packets may be charged.
If it is enabled and fails the detecting at the specified interval, retries and
destination, the router will re-dial the radio link automatically.
L-ICMP Detecting
It is the LAN side IP link status detecting, and it can be enabled or disabled. Also
the detecting interval (second), retries and destinations (host) can be specified.
If it is enabled and fails the detecting at the specified interval, retries and
destination, the router will be restarted automatically. For this reason, the
destination at LAN side should be set correctly and keep it working properly.
Otherwise, it will cause the router restarting frequently.
The default setting is “disable” since it may cause the router restarting.
IP Keeping
It keeps the IP link alive, and it can be enabled or disabled. The interval (second)
and destination (host IP address) can be configured.
The default setting is “disable” since the IP Keeping packets may be charged.
PPP Advanced Setting
Considering the difference of mobile network authorization, the Point to Point
Protocol connection should be compatible with different network. Advanced
setting is used for the PPP special setting. Click “PPP Advanced Setting” button to
start settings.