Sony BRS-200 - Manual (Page 17)

17
Control Panel
Cha
p
te
r 2
L
o
c
a
tions
and
F
u
n
c
tion
s
of
P
a
rt
s
2 CAMERA/DSK/AUX Bus Section
The buttons in this section differ in function depending on
whether the switcher is in CAM mode or SW mode. The functions of the buttons are explained for both modes
individually.
x Functions in CAM mode
a CAMERA buttons
Selects the connected camera to be controlled. The
selected camera button lights up.
To set up the selected camera, use the SETUP menu.
For details on setup of the camera, see “Setting Up the
VISCA Camera” on page 57.
Assign the VISCA cameras (BRC-300/300P, BRC-H700,
BRC-Z700 and BRC-Z330) to the CAMERA 1 to 7
buttons.
b P/T RST (pan/tilt reset) button
Hold this button pressed to reset the pan/tilt position of the
camera to the factory preset position.
c PST SPD (preset speed) button
Sets the pan/tilt speed at which the camera moves to the
preset pan/tilt position.
When you hold this button pressed, the CAMERA 1 to 7
buttons switch to function as pan/tilt speed setting buttons.
Pressing one of the CAMERA buttons allows you to set the
pan/tilt speed aligned to the pressed button.
For details, see “To set the camera moving speed to the
preset position ” on page 113.
d AUTO/MANUAL button
Each time you press this button, the focus mode of the
camera switches between AUTO and MANUAL. When
the button is lit, the focus mode is set to AUTO. The focus
mode is set to MANUAL when the button is not lit.
AUTO: The camera focuses on the subject in the center of
the screen automatically. The FOCUS control (page
24) and the O P AF button are disabled.
MANUAL: You can adjust the focus manually with the
FOCUS control (page 24) and the O P AF button.
For details, see “Adjusting the Focus of the Camera” on
page 104.
e O P AF (one-push auto focus) button
Press this button to perform one-push auto focus of the
camera when the focus mode is set to MANUAL with the
AUTO/MANUAL button.
f BK LIGHT (backlight) button
When the exposure mode of the camera is set to FULL
AUTO, SHUTTER Pri, IRIS Pri or GAIN Pri, pressing to
light up this button enables the backlight compensation
function of the camera.
Pressing this button again to make it go dark disables the
backlight compensation function.
For details, see “To enable backlight compensation” on
page 106.
CAM
CAMERA
DSK
LOW HIGH PRESET SPEED
P/T RST
PIP
PST SPD
AUX 1
AUTO/MANUAL
AUX 2
O P AF
PGM
BK LIGHT
PVW
SPT LIGHT
MV
O P AWB
CAMERA
DSK/AUX
SW
1 2 3 4 5 6 7 8 9 10 11 12
1 CAMERA buttons / DSK/AUX buttons
5 O P AF button / AUX 2 button
8 O P AWB button / MV button
7 SPT LIGHT button / PVW button
6 BK LIGHT button / PGM button
4 AUTO/MANUAL button / AUX 1 button
3 PST SPD button / PIP button
2 P/T RST button / DSK button
Note