Sony BRS-200 - Manual (Page 38)

38
Connecting External Equipment
Ch
apt
er 3 Prep
ar
at
ion
s
Connecting a Monitor or Projector Equipped with a DVI Input
You can monitor an image by connecting a computer display or projector
equipped with a DVI input to the DVI-I OUT connector on the switcher.
Installing the optional BRSA-20DD2 DVI output board to the OUT card slot on
the switcher enables connection of two monitors equipped with DVI inputs at
the same time.
Connecting a Computer for Storing the Setting Data
Connect the LAN (10/100) connector on the switcher to a computer’s LAN
connector with a cross-type LAN cable.
You can store the data such as snapshot, camera position and frame memory
image, set by the switcher in the connected computer, or import the data stored
in the computer to restore the previous status of the switcher.
* Some computers can be connected with a straight type LAN cable.
1 2 3 4 PGM1 PGM2 AUX1
SDI OUT SDI IN
AUX2 REF IN REF OUT RS-232C
~ AC IN
RS-422
DVI-I OUT DVI-I OUT
GENLOCK VISCA
GPI I/O PANEL LAN(10/100) REMOTE
IN1 IN2 OUT
– +
– + – + – + – + – +
Computer display, etc.
equipped with DVI input
DVI-I OUT DVI-I OUT
Projector, etc. equipped
with DVI input
BRSA-20DD2 DVI output board (not supplied)
1 2 3 4 PGM1 PGM2 AUX1
SDI OUT SDI IN
AUX2 REF IN REF OUT RS-232C
~ AC IN
RS-422
DVI-I OUT DVI-I IN
GENLOCK VISCA
GPI I/O PANEL LAN(10/100) REMOTE
5 6 7 8
SDI IN
IN1 IN2 OUT
LAN cable (cross cable
*
)
Computer
LAN (10/100)