Sanyo VCC-ZM300 - Manual (Page 48)

OPTION SETTING
ADDRESS setting
1 Use the cursor button (j or l) to move the cursor to
OPTION, then press the SET button.
The OPTION screen will appear.
Note: The PRESET ON setting cannot be used when OPTION
settings are in use.
2 Use the cursor button (j or l) to move the cursor to
ADDRESS, and then use the cursor button (d or c) to
select the address.
Available settings: 0 (d) ~ 127 (c)
☞ To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
ALARM setting
A Alarm input setting (ALARM IN)
Make the following settings for alarm detection.
Connect the external alarm switch to the alarm input terminal on
the back of the camera.
1
Use the cursor button (j or l) to move the cursor to
OPTION, then press the SET button.
The OPTION screen will appear.
Note: The PRESET ON setting cannot be used when OPTION
settings are in use.
2
Use the cursor button (j or l) to move the cursor to
ALARM, then press the SET button.
The ALARM SETTING screen will appear.
3 Use the cursor button (d or c) to select POLARITY
between “NO” and “NC”.
Available settings:
• NO: Normal open (Normally open so closed condition is
detected as input.)
• NC: Normal closed (Normally closed so open condition is
detected as input.)
1 2
MAIN MENU
LANGUAGE SET ‚
CAMERA ID OFF
SYNC INT
PRIVACY MASK SET ‚
LENS SET ‚
MIRROR OFF
VIEW SETTING 1 ‚
OPTION SET ‚
OPTION
CONTROL 485 ‚
ADDRESS 0
ALARM SET ‚
1 2
MAIN MENU
LANGUAGE SET ‚
CAMERA ID OFF
SYNC INT
PRIVACY MASK SET ‚
LENS SET ‚
MIRROR OFF
VIEW SETTING 1 ‚
OPTION SET ‚
OPTION
CONTROL 485 ‚
ADDRESS 0
ALARM SET ‚
L5AA2/US GB 2002, 5, 24
En
g
lis
h
47