SSD COMPANY LIMITED 420 - Manual (Page 16)

16 Microline 420/421 User’s Guide
Temporarily Changing the Top of Form
Position
Important
Do not use the platen knob to change the Top of Form. If you
turn the platen knob when the printer is turned on, the Top of
Form misaligns. Always turn the printer off before turning
the platen knob!
To move the Top of Form position lower for one page only:
1 Press SEL to deselect the printer.
2 Press LF to lower the position of the Top of Form.
Resetting Top of Form to the Factory Default
The factory default setting for the Top of Form (where the
printing should begin) is 1" down from the top of the page.
To reset the Top of Form to the factory default:
1 Remove paper from the paper path.
2 Turn the printer off.
3 Press and hold PARK + QUIET/TOF while turning on the
printer.
4 Reload paper.