SSD COMPANY LIMITED 420 - Manual (Page 24)

24 Microline 420/421 User’s Guide
Printer Reset
Clearing some error conditions requires that you reset
(reinitialize) the printer. To do this:
1 Press and release SEL (1) to take the printer off-line.
The SEL light goes out.
2 Press and hold SHIFT (2), then press the RESET /
CHARACTER PITCH key.
Important!
Pressing
SHIFT + RESET reinitializes the printer, but does not
affect any menu settings and does not reset the printer to the
factory defaults. For information on resetting the printer to
the factory defaults, see “Resetting the Menu to the Factory
Defaults” later in this chapter.
Emulations
• IBM ® Proprinter III — factory setting
• Epson ® FX
• Oki ® MICROLINE ®
Changing Emulations
1 Make sure paper is loaded.
2 Press and hold SHIFT (2), then press SEL (1).
3 Press LF (3).
The following line prints:
Printer Control Emulation Mode IBM PPR
4 Press TEAR (4) repeatedly until the emulation you wish to
select prints in the right-hand column.
5 Press and hold SHIFT (2), then press SEL (1) to save your
setting and exit the Menu Mode.