SpectronIQ PLTV-20NW32 - Manual (Page 12)

OMPLTV20NW32.book Monday, Dec. 04, 2006 9:37 PM
4
Setting Up the Display
C onnecting an A nalog TV Signal
An analog TV signal may come from a cable
box, satellite receiver, antenna, or similar
device.
To connect an analog TV signal source to the
display, connect a coaxial cable between the
NTSC input and the TV signal source (for
example, a cable box, satellite receiver, or
antenna).
N ote: If you would like to be able to
record the TV signal with a VCR,
DVD recorder, or similar device,
connect the TV signal source to
the input of the recording
device with one cable, then
connect the output of the
recording device to the NTSC
jack on the display with another
cable.
C onnecting C om posite Video D evices
Many video devices, such as VCRs, DVD
players, video game systems, and camcorders,
have composite video outputs. Composite
video uses one RCA cable to transmit video
information and generally provides lower
quality than S-Video, component video.
To connect a com posite video source to
the display:
1. Using an RCA cable, connect the
composite video output (yellow) on the
source device to the corresponding jack
in one of the composite video blocks on
the display
2. Using two other RCA cables, connect the
right (red) and left (white) audio outputs
on the source to the corresponding jacks
in the same composite video block used
above.
P C
A U D IO IN
V ID E O 1
AV 1 IN
AU D IO 1
S -V ID E O
S -