SpectronIQ PLTV-20NW32 - Manual (Page 20)

OMPLTV20NW32.book Monday, Dec. 04, 2006 9:37 PM
12
Using Your Display for the First Time
Setting up A nalog Television C hannels
Once an analog television signal is connected to the display, if you are connecting directly to a
wall jack or antenna, you should scan all channels to weed out channels with insufficient signal
strength. This will make it much easier to navigate through the channels.
To scan th e signal spectrum :
1. Turn the display on using the power button.
2. Press SOURCE until the signal source is set to TV.
3. Press ME NU to bring up the On-Screen Display (OSD).
4. Press
until the TV menu shows.
5. Press Source to enter the menu.
6. Press
until Channel System is
highlighted, then press Source to select it.
7. Press the and buttons until the
appropriate system is highlighted, then
press the Source button to select it.
Select Air if you are using an antenna.
Select one of the Cable options if you are connecting directly to a cable TV wall outlet.
Contact your cable service provider to find out which system is in use in your area. Cable or
Cable-IRC will work with most systems.
8. Press ME NU to return to the TV menu.
9. Press
until Auto Scan is highlighted and then press Source to select it. The display will
automatically scan all television channels for those with a strong signal.