SRS Labs CP-X505/CP-X605 - Manual (Page 18)

18
Operating
Searching an input signal
1. Press the SEARCH button on the remote control.
The projector will start to check its input ports in order to
¿QGDQ\LQSXWVLJQDOV
When an input is found, the projector will stop searching and display the image.
If no signal is found, the projector will return to the state selected before the
operation.
RGB 1 Æ RGB 2 Æ M1-D Æ COMPONENT (Y, C
B
/R
B
, C
R
/B
R
) Æ S-VIDEO Æ VIDEO
MAGNIFY MY BUTTON VOLUME
ON 1
MUTE
OFF 2
FREEZE KEYSTONE SEARCH
Selecting an input signal (continued)
1. Press the VIDEO button on the remote control to select an
input for video signal.
Each time you press the button, the projector switches its
video input port as below.
COMPONENT (Y, C
B
/R
B
, C
R
/B
R
) Æ S-VIDEO Æ VIDEO
Ɣ,IWKH9,'(2EXWWRQLVSXVKHG ZKHQVZLWFKLQJIURP5*%WR9,'(2VLJQDOV 
when TURN ON is selected for the AUTO SEARCH item in the OPTION menu
the projector will check the COMPONENT (Y, C
B
/R
B
, C
R
/B
R
) SRUW¿UVW,IQRLQSXW
is detected at the port, the projector will check other ports in above order.
STANDBY/ON VIDEO RGB
LASER
INDICATOR
Selecting an aspect ratio
1. Press the ASPECT button on the remote control.
Each time you press the button, the projector switches the mode for aspect
ratio in turn.
€ For an RGB signal
NORMAL Ж 4:3 Ж 16:9 Ж SMALL
€ For an M1-D signal
NORMAL Ж 4:3 Ж 16:9 Ж 14:9 Ж SMALL
€ For a video signal, s-video signal or component video signal
4:3 Ж 16:9 Ж 14:9 Ж SMALL
€ For no signal
  ¿[HG
Ɣ7KH1250$/PRGHNHHSVWKHRULJLQDODVSHFWUDWLRRIWKHVLJQDO
Ɣ3HUIRUPLQJWKHDXWRPDWLFDGMXVWPHQWLQLWLDOL]HVWKHDVSHFWUDWLRVHWWLQJ
ASPECT