Sennheiser Rack-mount Receiver EM 300 G3 - Manual (Page 61)

Index
60
Locked (lock mode activated) 23
Low Battery (warning message) 41
Low RF Signal (warning message) 41
M
Mains unit, connecting 19
Menu (main menu)
overview 27
settings 33
Mixing console/amplifier, connecting 17
Mounting
antennas 13
rack mount “ears” 12
receiver 12
Multi-channel operation 45
Mute (muting the audio signal) 24
Muting (audio signal) 24
N
Name (entering a name) 36
Network (connecting receivers in a
network) 18, 45
Network configuration, adjusting 42
O
Operating menu, using 29
P
Pilot tone evaluation, activating/
deactivating 40
R
Rack mount “ears”, Mounting 12
Rack mounting
one receiver 14
two receivers 16
Receiver
cleaning 48
connecting ~s in a network 18, 45
mounting into a rack 12
~ parameters (standard display) 10
placing onto a flat surface 12
switching on/off 20
synchronizing with transmitter 22, 44
Receiving frequency
selecting (Frequency Preset) 34, 38
setting (Tune) 38
Reception, optimizing 49
Reset List (releasing all locked frequency
presets) 34
RF (Radio Frequency) 10
RF Mute (warning message) 41
RX Mute (warning message) 41
RX Mute On/Off (muting the audio signal) 24
S
Scan New List (frequency preset scan) 34, 44
Setting up
multi-channel system 45
transmission link 44
Software Revision (displaying the software
revision) 43
Squelch (adjusting the squelch) 33
Switching on/off (receiver) 20
Sync Settings (submenu)
overview 28
settings 39
Synchronizing (transmitter with
receiver) 22, 44
T
Transmission link, setting up 44
Transmitter
adjusting the transmitter parameters
(Sync Settings) 39
synchronizing with receiver 22
synchronizing with receiver 44
Troubleshooting 50
Tune (setting the receiving frequencies and
frequency banks) 38
TX Mute (warning message) 41
U
Unlock (deactivating the lock mode) 23
Using
operating menu 29
Receiver 20
W
Warnings (Warnings)
overview of warning messages 41
activating/deactivating 41
WSM (Wireless Systems Manager) 18, 45