Safeline Sit'n'Stroll - Manual (Page 10)

Proper adjustment of the harness system for use forward-facing
1. Open the buckle by pressing the red button and pulling the latch plates from
5. Ensure the belts are not twisted.
6. Click the latch plates into the buckle. Pull up
on both latch plates to ensure they are securely
fastened.
7. Snap the chest clip back together. Slide the
chest clip so it is at your child’s armpit level. If
your child is smaller, you may need to remove
the shoulder pads to fully tighten the harness
and ensure proper placement of the chest clip.
8. Pull on the belt over the child’s left leg to snug
the harness. This belt goes under the seat and
attaches to the right lap and shoulder belts.
Tighten the harness by pulling the adjuster belt.
The harness should be tight enough for you to
only get one finger between the shoulder belt
and your child.
9. To loosen the harness, squeeze the adjuster
top and bottom and pull up.
Forward Facing Forward Facing Forward Facing Forward Facing Forward Facing
the buckle. Open the chest clip.
2. Place your child into the seat, making sure
their bottom is fully against the base of the
seat.
3. The shoulder straps should fit through the
shoulder belt slots, which are at or above the
Latch Plates
Crotch
Buckle
Red
Button
Chest
Clip
Adjuster
Crotch
Buckle
Latch
Plates
8 8 8 8 8
4. To move the straps to the proper slot position,
loosen the harness adjuster. At the back of the
Sit’n’Stroll
™ remove the shoulder belts from the
metal hooks. Pull the shoulder belts from the
front of the seat and place back through the
desired slots. Reattach the shoulder belts to
the metal hooks. Be sure the belts lay flat
against the back of the seat shell. If they are
over the stroller conversion handle you will not
be able to convert the Sit’n’Strol™
to stroller
mode.
Metal
Hooks