Safeline Sit'n'Stroll - Manual (Page 27)

The Sit’n’Str The Sit’n’Str The Sit’n’Str The Sit’n’Str The Sit’n’Stroll™ Sunshade oll™ Sunshade oll™ Sunshade oll™ Sunshade oll™ Sunshade
1. Attach the head rest clips to the top of edge of the seat back, on either side of
the handle tubes.
2. Push the edge of the seat cover forward exposing the plastic shell. Locate the
third hole down from the top.
3. Keep the seat cover fabric pushed forward and press the push pin (sewn into
the bottom portion of the sunshade) into the third hole until it clicks into place.
Repeat this procedure for both sides of the sunshade.
4. Pull the tension cords down and attach to the bottom of the seat (as shown)
to increase the sunshade’s coverage. Pull the tension cord back over the
sunshade and attach to the back of the seat in order to pull the shade away
from the baby.
Removing the Sunshade Removing the Sunshade Removing the Sunshade Removing the Sunshade Removing the Sunshade
1. Reach behind the seat shell and use your finger tips to press the push pins
outward until they pop free from the seat shell hole.
2. Carefully remove the remaining head rest clips and tension cord clips at-
tached to the side of the seat’s shell.
Attaching the Sunshade Attaching the Sunshade Attaching the Sunshade Attaching the Sunshade Attaching the Sunshade
Head Rest Clips (2)
Hole #1
Hole #2
Hole #3
Push Pin
Tension Cord
25 25 25 25 25