SiPix StyleCam Blink - Manual (Page 2)

ii
About this manual
This manual is designed to assist you in using the SiPix StyleCam Blink Digital Camera with
Streaming Snapshot mode. Information in this document has been carefully checked for
accuracy. However, no guarantee is given to the correctness of the contents. The information in
this document is subject to change without notice.
Edition
First Edition, February 2002
Copyright
© Copyright 2002
This document contains proprietary information protected by copyright. All rights are reserved. No
part of this manual may be reproduced by any mechanical, electronic or other means, in any
form, without prior written permission of the manufacturer.
Federal Communications Commission (FCC) Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
♦
Reorient or relocate the receiving antenna.
♦
Increase the separation between the equipment and the receiver.
♦
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
♦
Consult the dealer or an experienced radio/TV technician for help.
Warning: A shielded-type power cord is required in order to meet FCC
emission limits and to prevent interference to the nearby radio and television
reception. Use only shielded cables to connect I/O devices to this equipment.
You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.