SiPix StyleCam Blink - Manual (Page 8)

4
Inserting & Removing the Battery
Please follow the instructions below to insert the battery.
Inserting Battery
1. Make sure the Power of the camera is OFF.
2. To open the battery compartment cover on the back of the camera, slide the entire
cover in the direction indicated by the arrow on the cover; the cover will slide open.
3. Note the battery polarity inside the battery compartment, and insert the battery
accordingly. Make sure you insert the batteries on top of the blue strip.
4. Close the battery compartment cover by sliding it back until it clicks.
Removing Battery
1. Maker sure the camera’s power is OFF.
2. To open the battery compartment cover on the back of the camera, slide the entire
cover in the direction indicated by the arrow on the cover; the cover will slide open.
3. Pull on the blue strip to pop out the battery.
4. Close the battery compartment cover by sliding it back until it clicks.
Note: Use only AAA alkaline or rechargeable NiMH batteries.
Inserting the battery with the incorrect polarity may cause damage to
the camera or battery.