SiPix StyleCam Blink - Manual (Page 9)

5
Camera Setup & Operation
The instructions below will guide you through the basic functions of the StyleCam Blink and how it
operates.
HOW TO SET UP THE STYLECAM BLINK
Press the MODE button to select the function you need. (See Identifying Components on
page 3)
The function icon on status display will blink, and then press the SHUTTER button until you
hear two (2) beeps to select. The mode will change.
The function mode status flow is as follows:
Please refer to the icon description in Identifying Components on page 3.
HOW TO USE THE STYLECAM BLINK
Turning the Camera On/Off
1. Power ON: Press and release the MODE button, and the camera will beep.
2. Power OFF: Press and hold the MODE button until the camera beeps twice, then
release the button.
3. Auto Power Off: The camera will turn off automatically if it is inactive for 60 seconds.
Selecting Image Resolution
The StyleCam Blink has two resolution settings: VGA (640 x 480 pixels) or CIF (320 x 240
pixels).
1. Press the MODE button until the desired resolution is selected, VGA or CIF.
2. Press and hold the SHUTTER button until the camera beeps twice to select your
desired setting.
Selecting An Environment
The StyleCam Blink has two environments you can choose from: outdoor mode or indoor
mode.
1. Press the MODE button to scroll to the outdoor icon or the indoor icon.
2. Press and hold the SHUTTER button until the camera beeps twice to select your
desired setting.
Important Note: If the subject area is too dark, the camera will emit three beeps when the
SHUTTER button is pressed, and the image will not be recorded.