Sony 3-299-270-21(2) - Manual (Page 26)

26 GB
Performing the Auto
Calibration
1
Press ?/1 .
The system turns on.
2
Press AMP MENU.
Point the remote at the remote sensor ( ) on
the remote commander receiver.
3
Press x/X repeatedly until “A. CAL
MENU” appears on the top panel
display, then press
or c.
4
Press x/X to select “A. CAL START,”
then press .
The Auto Calibration starts after the
countdown.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
• If “PHONES” appears, you cannot perform the Auto
Calibration. Disconnect the headphones from the S-
AIR product you are using, then restart the Auto
Calibration.
• If “CHECK MIC” appears, you cannot perform the
Auto Calibration. Connect the calibration mic, then
restart the Auto Calibration.
• When the Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure. This
is because test signals are output from the speakers
during measurement.
– Avoid making noise to get a more accurate
measurement.
To cancel the Auto Calibration
The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press .
– Press input buttons on the remote or INPUT
SELECTOR on the subwoofer.
– Change the volume level.
1 2 3
4 6
7 8
0 ENTER CLEAR
9
THEATRE
TV ?/1
AV ?/1
TV BD DVD SAT
TOP MENU MENU
BD/DVD
RETURN/EXIT
TV
F1 F2
AMP MENU
DISPLAY
TONE
TUNING - TUNING +
NIGHT
MODE
A/B DIGITAL ANALOG
DMPORT TUNER/BAND VIDEO SOUND FIELD
?/1
TV CH -
PRESET -
TV CH +
PRESET +
F
G g
f
.
H m M
X x
< < >
5
SYSTEM STANDBY
MENU/HOME
TOOLS/
OPTIONS
C, X, x, c,
?/1
AMP
MENU
Input
buttons
Remote commander receiver
Remote sensor
Measurement for Display
Speaker existance TONE
Speaker gain, distance, frequency
response T.S.P.
Subwoofer gain and distance SUBWOOFER
Notes
Tip