Sierra Wireless DART 200 CDPD Modem - Manual (Page 161)

DART 200 CDPD Modem User’s Guide F DART AT Command Set
PN1197-00 Revision 1.0 F-17
Table F-3. Commands beginning with backslash (\) (cont.)
\R
(cont.)
Format:
AT\R2 Register when connection is established, deregister when connection is
terminated. Can be used only if the modem is operating as a client.
AT\R3 Turn off \R2 option
AT\R4 Auto-register when modem is powered on. If S-Register 13 is set to zero this
option puts the modem into automatic registration mode.
AT\R5 Turn off \R4 option
Result codes:
OK Command successful
ERROR Unsuccessful completion; see S-Register 56
NOT ENABLED PIN Required; see *E command
\S Set Subscriber Identity
Displays the modem's NEI (IP Address) list (or configuration), and also to select or deselect, the NEI to
be used for network registration. It supports both point-to-point (normal) and multicast (if being used)
IP Addresses. The CDPD Service Provider provides the IP addresses.
NOTE:
The multicast NEI must be selected prior to registering the point to point NEI since they must be
registered as a pair.
Format:
AT\Sn Select the NEI in slot <n> as the active IP Address, where <n> = 0 - 9.
AT\S+n Select the NEI in slot <n> as the multicast IP Address. The active NEI slot may
not be selected.
AT\S-n De-select address <n> as the active or multicast NEI
AT\S? Display the IP Address list. The active NEI is marked by an <*>, the selected
multicast NEI is marked by a <+>
Result codes:
OK Valid argument
ERROR Invalid argument