Sierra Wireless DART 200 CDPD Modem - Manual (Page 172)

DART 200 CDPD Modem User’s Guide F DART AT Command Set
Sierra Wireless, Inc. F-28
Table F-6. Service Provider commands beginning with caret (^) (cont.)
^H
(cont.)
Result codes:
OK Valid argument
ERROR Invalid argument
NOT ENABLED Modem is not in service provider mode
^I Set the Service Provider Network ID (SPNI)
Loads a SPNI into one of the 10 slots (numbered 0 - 9) in the DART’s SPNI table. Refer to the \J
command in Chapter 2, Installation and Setup, Initial testing, for more information.
Format:
AT^I<i>/<n> where: <i> = 0 to 65535
<n> = 0 to 9; default is 0; (see AT^A)
example: AT^I250/0
AT^I-<n> This form of the AT^I command is used to remove the SPNI in slot n of the
SPNI table.
AT^I? Display current SPNI table entries
Result codes:
OK Valid argument
ERROR Invalid argument
NOT ENABLED Modem is not in service provider mode
^L Set the Local Service Area ID (LSAI) for CDPD 1.0 mode, or the Wide Area
Service Identifier (WASI) for CDPD 1.1 mode
Loads the LSAI or the WASI into one of the 10 slots (numbered 0 - 9) in the DART’s LSAI/WASI
table. Refer to the \J command in Chapter 2, Installation and Setup, Initial testing, for more
information.
Format:
AT^L<w>/<n> where: <w> = 0 to 65535
<n> = 0 to 9; default is 0; (see AT^A)
example AT^L250/0
AT^L-<n> This form of the AT^L command is used to remove the WASI in slot n of the
LSAI/WASI table.
AT^L? Display current LSAI/WASI table entries
Result codes:
OK Valid argument
ERROR Invalid argument
NOT ENABLED Modem is not in service provider mode