Sony XAV-A1 - Manual (Page 35)

35
Sound settings
— SOUND
“SOUND” setting allows you to adjust the
sound according to the playback conditions
and connected equipment.
On the monitor
1
Touch SOURCE LIST.
2
Touch MENU.
The system menu appears.
3
Touch SOUND.
4
Adjust the Sub, Bass or Treble level
touching the – or +.
Sound
ATT
CLOCK MONITOR DSPL OTHER
Sub
Bass
Treble
Balance
DVD Level Adjust
Rear Att
Beep
,
SOURCE LIST
SOUND
♦
Balance
Adjusting the balance of each speaker.
Balance
Back Reset
F
L R
R
Touch F/R or L/R of the table on the monitor
to adjust the balance by step. You can also
touch the desired point directly to adjust the
balance.
To reset the setting, touch Reset.
♦
Rear Att
Reducing the audio output level of the REAR
MONITOR OUT if the playback sound is
distorted.
This setting affects the output of the REAR
MONITOR OUT.
Rear Att On Reducing the audio output level.
Select this if the playback sound from
the speakers (rear monitor) is
distorted.
Rear Att Off Normally, select this position.
This setting is available only for DVD or
VCD.
♦
DVD Level Adjust
The audio output level for DVD video differs
depending on the recorded audio format
(PCM, Dolby Digital or DTS). You can adjust
the output level of PCM, Dolby Digital or
DTS separately to reduce the volume level
differences between disc and format.
To adjust the output level, see page 31.
♦
Beep
Turning the beep sound on or off.
Beep On Turns the beep sound on.
Beep Off Turns the beep sound off.
Tips
• When an optional power amplifier is connected, and
you are not using the built-in amplifier, the beep does
not sound even if it is set to Beep On.
• The beep sound for warning will sound even if it is set
to Beep Off.
• The default settings are underlined above.