Sony XAV-A1 - Manual (Page 36)

36
Other settings
— OTHER
♦
AUX 3
You can set the function of the AUX3 jack.
When you connect the back camera to AUX3
jack, set to “Back Camera”. To adjust the
position of the back camera while viewing
the image of the camera, set to “Normal”.
Normal • Select this when you connect the
other components other than back
camera to AUX3 jack.
• Select this to test view while
connecting the back camera.
You can adjust the position of the
back camera while viewing the
image of the camera without setting
the shift lever to the “R(reverse)”
position. However, note that the
image of the camera will be
displayed only when the parking
brake is set.
Back Camera Select this when you connect the back
camera to AUX3 jack.
♦
Switching the NTSC/PAL system
You can switch the NTSC/PAL system of the
back camera in the AUX 3 mode.
Press and hold SEEK + of the main unit for 3
seconds while in AUX3 mode. The short beep
sounds and NTSC/PAL system is now
switched.
NTSC Switches the back camera to NTSC
system.
PAL Switches the back camera to PAL
system.
Note
This setting is available also when AUX 3 is set to
“Normal”.
♦
PBC On
Switching on and off the PBC function of
VCDs. Available only when VCD is stopped.
PBC On Turns on the PBC function.
PBC Off Turns off the PBC function.
Using the System Menu
♦
Demo
Switching on and off the Demo mode. The
Demo screen is displayed only when the
power is off.
Demo On Turns on the Demo mode.
Demo Off Turns off the Demo mode.
Tip
The default settings are underlined.
♦
Touch Panel Adjust
If the touching position does not correspond
with the proper item, you will need to adjust
the touch panel position.
Touch 1, 2 and 3 of the touch panel in order.
2
1
3