Configuration management commands, Cfgclear, Cfgdisable – StorageTek StorageNet 4000 User Manual
Page 33: Cfgenable, Configuration management commands -7, Cfgclear -7, Cfgdisable -7, Cfgenable -7, Figure 4-16, Cfgclear command -7
Configuration Management Commands
8946121502
4-7
Configuration Management Commands
Configuration Management commands allow you to configure the zones.
cfgClear
shows the cfgClear command. This command should be used with caution.
Figure 4-16 cfgClear Command
If a zone configuration is enabled, it is first disabled. All defined zone objects are then deleted.
The zone configuration stored in flash memory is erased. After this command is executed there
is no longer any zone information stored in the Fabric.
Note:
Using this command removes all zone information from the Fabric.
cfgDisable
shows the cfgDisable command. This command disables the current zone
configuration. The Fabric returns to non zoning mode where all devices see each other.
Figure 4-17 cfgDisable Command
cfgEnable
shows the cfgEnable. This command enables the current zone configuration.
Figure 4-18 cfgEnable Command
The specified zone configuration is compiled by checking for undefined zone names, zone
alias names, or other inconsistencies by expanding zone aliases, removing duplicate entries,
and then building the effective configuration. If the compilation fails, the previous state is
unchanged. (ZONING is disabled if it was previously disabled or the previous effective
configuration remains in effect.) If the compilation succeeds, the previous effective
configuration is disabled and this new configuration is installed.
admin> cfgClear
value = 0 = 0x0
admin> cfgDisable “USA_cfg”
value = 0 = 0x0
admin> cfgEnable “USA_cfg”
zone config “USA_cfg” is in effect
value = 0 = 0x0