Cfgsave, Cfgshow, Cfgsave -8 – StorageTek StorageNet 4000 User Manual
Page 34: Cfgshow -8, Figure 4-19, Cfgsave command -8, Figure 4-20, Cfgshow command -8
Configuration Management Commands
4-8
8946121502
cfgSave
shows the cfgSave command. Use this command to write a copy of the defined
configuration plus the name of the effective configuration to flash memory in all Fabric
switches.
Figure 4-19 cfgSave Command
The saved configuration automatically reloads when the switch is powered up. If a
configuration was in effect when it was saved, the same configuration is reinstated with an
automatic cfgEnable command.
cfgShow
shows the cfgShow command output. Use this command for output for the
specified zone configuration definition if a parameter is given (otherwise all zone
configuration information is printed).
Figure 4-20 cfgShow Command
admin> cfgSave
Updating flash ...
value = 0 = 0x0
admin> cfgShow
Defined configuration:
cfg: USA1 Blue_zone
cfg: USA_cfg Red_zone; Blue_zone
zone: Blue_zone
0,1; array1; 0,2; array2
zone: Red_zone
0,0; loop1
alias: array1 21:00:00:20:37:0c:76:8c; 21:00:00:20:37:0c:71:02
alias: array2 21:00:00:20:37:0c:76:22; 21:00:00:20:37:0c:76:28
alias: loop1 21:00:00:20:37:0c:76:85; 21:00:00:20:37:0c:71:df
Effective configuration:
cfg: USA_cfg
zone: Blue_zone
0,1
21:00:00:20:37:0c:76:8c
21:00:00:20:37:0c:71:02
0,2
21:00:00:20:37:0c:76:22
21:00:00:20:37:0c:76:28
zone: Red_zone
0,0
21:00:00:20:37:0c:76:85
21:00:00:20:37:0c:71:df
value = 1 = 0x1