Sun Microsystems X1150A - Manual (Page 60)

38 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003
Note – The syntax for the Sun GigaSwift Ethernet driver parameters has changed.
The syntax for parameters formerly included an underscore, for example,
adv_autoneg_cap . The current syntax uses a dash instead, for example,
adv-autoneg-cap . During the transition phase, either format is acceptable.
However, be sure to check the Platform Notes: Sun GigaSwift Ethernet Device Driver in
your version of the Solaris operating environment.
Driver Parameter Values and Definitions
TABLE 4-1 describes the parameters and settings for the ce device driver.
TABLE 4-1 ce Driver Parameter, Status, and Descriptions
Parameter Status Description
instance Read and write Device instance
adv-autoneg-cap Read and write Operational mode parameter
adv-1000fdx-cap Read and write Operational mode parameter
adv-1000hdx-cap Read and write Operational mode parameter
adv-100T4-cap Read and write Operational mode parameter
adv-100fdx-cap Read and write Operational mode parameter
adv-100hdx-cap Read and write Operational mode parameter
adv-10fdx-cap Read and write Operational mode parameter
adv-10hdx-cap Read and write Operational mode parameter
adv-asmpause-cap Read and write Flow control parameter
adv-pause-cap Read and write Flow control parameter
master-cfg-enable Read and write Gigabit link clock mastership controls
master-cfg-value Read and write Gigabit link clock mastership controls
use-int-xcvr Read and write
enable-ipg0 Read and write Enable additional delay before transmitting a packet
ipg0 Read and write Additional delay before transmitting a packet
ipg1 Read and write Interpacket Gap parameter
ipg2 Read and write Interpacket Gap parameter
rx-intr-pkts Read and write Receive interrupt blanking values
rx-intr-time Read and write Receive interrupt blanking values