Sun Microsystems X1150A - Manual (Page 90)

66 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003
Tagging an Ethernet frame requires the addition of a tag header to the frame. The
header is inserted immediately following the Destination MAC address and the
Source MAC address. The tag header consists of two bytes of Ethernet Tag Protocol
Identifier (TPID, 0x8100) and two bytes of Tag Control Information (TCI).
FIGURE 5-2
shows the Ethernet Tag Header format.
FIGURE 5-2 Ethernet Tag Header Format
By default, a single VLAN is configured for every port, which groups all ports into
the same broadcast domain, just as if there were no VLANs at all, VLAN tagging for
the switch port turned off.
Note – If you configure a VLAN virtual device for an adapter, all traffic sent or
received by that adapter must be in VLAN-tagged format.
▼ To Configure Static VLANs
1. Create one hostname6.cenum file for each VLAN which will be configured for each
adapter on the server, using the following naming format that includes both the
VID and the physical point of attachment (PPA):
VLAN logical PPA = <1000 * VID> + <Device PPA>
ce123000 = 1000*123 + ce
This format limits the maximum number of PPAs (instances) you can configure to
1000 in the
/etc/path_to_inst file.
For example, on a server with the Sun GigaSwift Ethernet adapter having an
instance of 0, that belongs to a member of two VLANs, with VID 123 and 224, you
would use
ce123000 and ce224000 , respectively, as the two VLAN PPAs.
TPID (0x8100
3 bits 1
bit
12 bytes
User_priority CFI VID
Octet
1
2
3
4