Sun Microsystems X1150A - Manual (Page 61)

Chapter 4 Configuring Driver Parameters 39
Operational Mode Parameters
The following parameters determine the transmit and receive speed and duplex.
TABLE 4-2 describes the operational mode parameters and their default values.
red-dv4to6k Read and write Random early detection and packet drop vectors
red-dv6to8k Read and write Random early detection and packet drop vectors
red-dv8to10k Read and write Random early detection and packet drop vectors
red-dv10to12k Read and write Random early detection and packet drop vectors
tx-dma-weight Read and write PCI Interface parameter
rx-dma-weight Read and write PCI Interface parameter
infinite-burst Read and write PCI Interface parameter
disable-64bit Read and write PCI Interface parameter
TABLE 4-2 Operational Mode Parameters
Parameter Description
adv-autoneg-cap Local interface capability advertised by the hardware
0 = Forced mode
1 = Autonegotiation (default)
adv-1000fdx-cap Local interface capability advertised by the hardware
0 = Not 1000 Mbit/sec full-duplex capable
1 = 1000 Mbit/sec full-duplex capable (default)
adv-1000hdx-cap Local interface capability advertised by the hardware
0 = Not 1000 Mbit/sec half-duplex capable
1 = 1000 Mbit/sec half-duplex capable (default)
adv-100T4-cap Local interface capability advertised by the hardware
0 = Not 100T4 capable (default)
1 = 100T4 capable
adv-100fdx-cap Local interface capability advertised by the hardware
0 = Not 100 Mbit/sec full-duplex capable
1 = 100 Mbit/sec full-duplex capable (default)
TABLE 4-1 ce Driver Parameter, Status, and Descriptions (Continued)
Parameter Status Description