Standers 580 - Manual (Page 18)

User Guide
10 2130374
Part 1: AirCard 580 software
installation
Windows 98 SE, Me, 2000, and XP
installation procedures
To install Watcher and the AirCard 580 drivers:
Windows 2000 & XP: You may require administrative privileges to
install the AirCard 580.
1. The Installation CD launches automatically. Select Install
Watcher and a welcome window appears.
2. Click Next on the Watcher Setup Welcome window.
3. Use the Next and Back buttons to navigate through the
wizard noting the following:
· You must click Yes to indicate your acceptance of the
terms of the license agreement to proceed with the
installation.
· Use the default settings for the Destination Location and
Program Folder unless you have special requirements and
an advanced understanding of PC configuration. (The
Destination Location dictates where the software is
installed. The Program Folder dictates the name assigned
to the software in Add/Remove Programs in the Control
Panel.)
· To customize Watcher to launch automatically each time
your notebook PC starts up, select the
Run Watcher at
Start up check box. To add the Watcher shortcut to your
desktop, providing you with the option of launching
Watcher by double clicking an icon on your desktop (as
well as from the Start menu), select the
Desktop Shortcut
check box. (You may select both).
· Click Finish to close the last screen of the wizard.
Processor Pentium 150 MHz or higher
Memory at least 32 MB
Disk Space at least 14 MB
Dial-up Networking DUN bound to TCP/IP
Table 3-1: System Resource Requirements (cont.)