Standers 580 - Manual (Page 27)

Watcher™ Basics
v2.1 May.04 19
Note: A “No Service” message
appears when the AirCard 580
cannot locate the network. 1. Click the Connect button to establish a connection.
Figure 4-2: Watcher in Full Mode view - Connect action button
2. Watcher will take a few moments to connect to the
network. Once a connection is established, the dialog box
at the bottom of the Watcher window displays the word
“Connected,” notifying that a connection has been estab-
lished. The
Connect button changes to read Disconnect .
Disconnect
1. To end the current connection, click the Disconnect button.
Figure 4-3: Watcher in Full Mode view - Disconnect action button
2. The dialog box returns to the “ Ready ” state, notifying that
the current session is no longer active.