Standers 580 - Manual (Page 21)

Installation Procedures
v2.1 May.04 13
4. Select the following menu selection from the ʺ Unplug or
Eject Hardware ʺ window for your operating system and
click Stop to proceed:
· Windows 98 SE and Me ONLY: Select ʺ Wireless PC Card
USB Open Host Controller ʺ
· Windows 2000 ONLY: Select “Standard OpenHCD USB
Host Controller”
· Windows XP ONLY: Select “Lucent USB OpenHost
Controller”
5. Select the appropriate menu selection for your operating
system from the "
Stop a Hardware Device " window. (Refer to
step 4)
Tip: Windows shortcut for
Unplug/Eject and Stop Hardware
steps: Left-click on the "Unplug
and Eject Hardware" icon found
in the system tray. A menu
appears. Select the appropriate
selection for your operating
system (see step 5) and click OK
when the Safe to Remove
Hardware window appears
.
6. Once the “ Safe to Remove Hardware” message appears, click
OK .
7. You may now remove the AirCard 580 from your
notebook. Use the ejector button on your notebook to eject
the AirCard 580 from the slot. Do not pull the AirCard 580
out by the antenna.
Figure 3-5: Proper PC card insertion and removal
Driver installation
driver:
A driver is software that provides the interface between
a device (such as the AirCard 580) and the operating
system on your PC (such as Windows Me).
1. Once the card is properly inserted, your Windows
operating system will notify you that new hardware has
been detected. Please review the following notes :