SUUNTO MARINER | REGATTA | YACHTSMAN - Manual (Page 15)

8
1.4 MEASUREMENTS AND UNITS
The Wristop Computer supplies two units of measure: metric or imperial.
Metric Unit of Measure
Imperial Unit of Measure
°C °F
mbar inHg
m ft
1.4.1 Selecting the Units of Measurement
To change the unit of measure displayed:
1. Check the mode indicator. If the mode arrow is not on TIME, PRESS the [Mode] button until the arrow is
directly below TIME on the Mode Indicator Bar.
2. PRESS the [Mode] and [Select] buttons simultaneously and hold in for 3 seconds. Field 1 will display “SET”
momentarily and then display “UNI” (Fig. 1).
WARNING: If the user presses the [Select] button (and does not hold for 2 seconds) while in the “UNI” setting
mode, the user will be in the Pressure Sensor Calibration. Refer to the next section for details.
3. PRESS the [Select] button and hold in for 2 seconds. Located to the right in Field 2, “mbar” or “inHg” will
begin to flash.
4. PRESS the [+] button to toggle between “mbar” and “inHg”.
5. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located at the top right
in Field 1, °C or °F will begin to flash.
6.PRESS the [+] button to toggle between °C and °F.
7. At the unit of measure desired, PRESS the [Select] button to move to the next unit. Located to the right in
Field 2, “m” or “ft” will begin to flash.
8. PRESS the [+] button to toggle between “m” and “ft”
9. At the unit of measure desired, PRESS the [Mode] button to accept the changes. PRESS the [Mode] button
again to return to the main time mode.