Saleen 10-8002-C11790A - Manual (Page 16)

16
VIII Front Sway Bar Installation
Part Number Description Qty.
06-1303-B09915* Swaybar Front Assembly 1
Figure 1
Figure 2
Order of Operations:
1. Put the new sway bar into the
location where the stock sway bar
went.
2. Align the bushing brackets over the
existing studs. (Figure 2)
3. Fasten down the new sway bar using
the stock nuts over the inboard studs
and new bushings brackets. There are
a total of four nuts. Use a 3/8” impact
gun with a 15 mm socket. (Figure 2)
Torque nuts to 52 ft-lbs.
4. Attach the ends of the sway bar to the
bottom of the end links, and put the
stock nut in place over each bottom
end link stud. Tighten nut using the
3/8” impact gun and 18 mm deep
socket. Torque nuts to 85 ft-lbs.
5. Remove the white cover from the
front strut decals.
6. Jack the front of the car up, remove
the jack stands, and lower the car
back to ride height.
Obtain the following tools:
• 3/8” impact gun
• 15 mm deep socket, 3/8” drive
• 18 mm deep socket, 3/8” drive
• Ft-lb torque wrench, ½” drive
• 15 mm deep socket, ½” drive
• 18 mm deep socket, ½” drive
Front of
car