Saleen 10-8002-C11790A - Manual (Page 19)

19
X Rear Suspension Installation
Part Number Description Qty.
06-1302-C09818 Shock Rear Coupe 2
06-1302-C09819 Spring Rear Coupe 2
Figure 1
Figure 2
Order of Operations:
1. Place the top of the spring (the end with
the shorter vertical distance between
coils) into the mounting location, making
sure the stock rubber boot is in place.
The top of the spring has shortened
vertical distances between the coils.
Install both springs before next step.
Make sure to use the stock rubber boots
on top and bottom of the springs. (Figure
1)
2. Put the bottom of the shock into the
bolting location. With the top lined up
with the trunk hole, tighten bottom of
shock. Decal faces rear fascia. Use a 15
mm socket with a 3/8” impact gun.
(Figure 2) Repeat on other side.
3. Remove the white cover from the shock
decal.
Obtain the following tools:
• 3/8” impact socket
•
15 mm shallow wobbly
socket, 3/8” drive
• Small flat head screw driver
• Needle nose pliers
•
13/16 deep socket, ½” drive
• 10 mm wrench
•
Hack saw
• Ft-lb torque wrench, ½” drive