When "paper selection" is set to "auto select, When "forced output of print" is disabled, When "forced output of print" is enabled – Sharp AR-M257 User Manual

Page 184: Basic printing, Part 2)

Advertising
background image

1

PRINTING FROM WINDOWS

8

C O N T E N T S

Basic printing

(part 2)

5

Click the "Print" button ("OK" button in
Windows 98/Me/NT 4.0).

Printing begins. The print job is delivered to one of the
following trays (depending on which output devices are
installed):

Job separator tray kit is installed: Upper tray

Finisher is installed: Center tray

When "Paper Selection" is set to "Auto Select"

If "Paper Selection" is set to "Auto Select" in the "Paper" tab of
the printer driver setup screen and the correct size of paper for
a print job is not loaded in the machine, the printing procedure
will vary depending on the "FORCED OUTPUT OF PRINT"
setting in the key operator programs (see the key operator's
guide).

When "FORCED OUTPUT OF PRINT" is disabled

If the bypass tray can be used, a message prompting you to
print from the bypass tray will appear in the touch panel.
Press the [PRINT] key on the operation panel, touch the
[BYPASS TRAY] key, load paper in the bypass tray, and then
touch the [BYPASS] key. Printing will begin automatically.

When "FORCED OUTPUT OF PRINT" is enabled

Printing will take place using a size of paper that is close to the
size of the print image.

The output tray can be selected in the key operator
programs (see "OUTPUT TRAYS" in the key
operator's guide).

The output tray can also be selected in the print
settings at the time of printing. To change the tray
selection, select the desired tray in "Output" in the
"Paper" tab of the printer driver setup screen.

Printing can be canceled in the job status screen.

Canceling a print job

If the paper type setting in the printer driver is different
from the bypass tray's paper type setting in the
machine, printing may stop. To resume printing, press
the [PRINT] key on the operation panel, touch the
[BYPASS TRAY] key in the touch panel, and specify
the same paper type as in the printer driver.

Note

If the paper is loaded in a different orientation than the
print image, the image is automatically rotated to match
the paper. This setting can be changed in the key
operator programs (see "ROTATED PRINT" in the key
operator's guide).

Note

Advertising
This manual is related to the following products: