Sangean DCR-200 - Manual (Page 12)

11
Operating your digital receiver – DAB
1. Press the Standby button to switch on the digital receiver.
If the digital receiver has been used before the last used mode
will be selected.
2. Press and release the Band button as needed so that DAB mode is
selected on the display.
3. If this is the first time the digital receiver is used a full scan of the
DAB channels in your country will be carried out. The display will
show “Tuning” for a few seconds. (If the digital receiver has been
used before the last used station will be selected).
4. The first station in the list of stations found during the scanning
process will be played. The display will show the station name.
5. If no signals are found, the digital receiver will show “OFF AIR” and it
may be necessary to relocate your digital receiver to a position giving
better reception, and then repeat the scan following above procedure.
2
1