Sangean DCR-200 - Manual (Page 19)

18
GB
Operating your digital receiver – Search tuning FM
1. Press the Standby button to switch on your digital receiver.
2. Press the Band button as needed until the FM band is selected.
3. Press and release the Auto-tune button to carry out an auto-tune.
Your digital receiver will scan up the FM band from the currently
displayed frequency and will stop scanning automatically when it
finds a station of sufficient strength. To scan down the FM band,
press and hold the Auto-tune button.
4. The display will show the frequency of the signal found. If the signal
is strong enough and there is RDS information available, soon after
the display will show the radio station name.
5. To find more FM stations press and release the Auto-tune button to
repeat the scan operation as DAB stations before.
6. When the end of the waveband is reached your digital receiver will
recommence tuning from the opposite end of the waveband.
7. Use the Volume control to adjust the sound level as required.
2
3,5
7
1