Sangean DCR-200 - Manual (Page 25)

24
GB
Clock and Alarms
Automatically updating the clock
Your digital receiver will normally update the clock automatically when
tuning to the radio broadcast. After a power failure the digital receiver
will then set its clock the next time that you turn on the digital receiver
in DAB or FM mode.
When the digital receiver is in Standby mode, the clock will be
automatically synchronized with DAB radio.
Setting the time format
The clock display used in stand-by mode and on the playing mode
screens can be set to 12 or 24 hour format. The selected format is then
also used when setting the alarms.
1. With your digital receiver switched on, press and hold down the
Menu button until the display shows “ALARM 1” flashing.
2. Rotate the Tuning control until “TIME FMT” shows on the display.
Press the Tuning control to enter the system settings menu.
3. Rotate the Tuning control to select either 12 or 24 hour format.
Press and release the Tuning control to confirm your choice of
clock format. The display will then revert to the previous menu.
If the 12 hour clock format is chosen, the digital receiver will then use
the 12 hour clock for the setting of alarms, and will display a 12 hour
clock for the setting of alarms, and will display a 12 hour clock with an
AM or PM indicator when in stand-by mode.
2,3